Ridgid 64053 STRUTSLAYR

The Ridgid® StrutSlayr™ delivers fabrication shop quality, burr-free strut channel cuts on the jobsite in less than 5 seconds. Compatible with Ridgid 32kN press tools, the StrutSlayr offers minimal sparking versus grinders and chop saws and a clean, consistent cut at the pull of a trigger. Press tools are not included. Not compatible with Ridgid 320-E or CT-400.

• Features:
• Fab Shop Quality
• Burr-free* cuts eliminate the need for extra filing
• Increased Efficiency
• Clean, consistent cuts in 5 seconds or less
• Safe Operation
• Minimal sparking verses grinders and chop saws
• Portable
• Easy to move aroun the job site and mounts to Ridgid Tristands
• Built-in Measuring Guide
• Allows accuracy on the job site
• *Burr free with dedicated 1-5/8" x 1-5/8" (41mm x 41mm) or 1-5/8" x 13/16" (41mm x 21mm) dies.

• Specifications:
• Cutting Capability: Up to 12ga 1-5/8" x 1-5/8" (41mm x 41mm x 2.5mm) or 1-5/8" x 13/16" (41mm x 21mm x 2.5mm) strut channel to the MFMA-4 Standard. Not for use with stainless steel strut.
• Weight of Head: 12 lbs. (5.4 kg) (including dies, not including press tool)
• Press Tool Compatibility: Ridgid™ Standard Series 32kN Press Tools (such as the Ridgid RP340 and RP330). Not for use with Ridgid 320-E and CT-400 Press Tools
• Cut Squareness: +/- 2° (strut must extend past strut support)
• Shearing Dies: 1-5/8" x 13/16" (41mm x 21mm) Dedicated Die
  1-5/8"x 1-5/8" (41mm x 41mm) Dedicated Die
  1-5/8" x 13/16" (41mm x 21mm) and 1-5/8" x 1-5/8" (41mm x 41mm) Combo Die